Table Of Contents; Introduction - Husqvarna ST 424 Operator's Manual

Introduction.................................................................10
Safety........................................................................... 11
Assembly.....................................................................14
Operation.....................................................................15
Maintenance................................................................ 18
Product overview
(Fig. 1 )
1. Fuel tank cap
2. Muffler
3. Oil fill/dipstick (for ST 424T/427T/430T only)
4. Battery cover
5. Discharge chute lever
6. Auger engagement
7. Drive speed lever
8. Control panel
9. Remote control lever
10. Drive engagement
11. Steering triggers
12. Handle knobs
13. Wheel (for ST 424/427/430 only)
14. Dipstick (for ST 424/427/430 only)
Product overview
(Fig. 2 )
1. Adjustment lever for the auger bucket
2. ON/OFF switch for the heated grip
3. Hour meter and oil change reminder
4. Throttle
5. Discharge chute lever
6. Release lever
7. Ignition slot
8. Auger engagement
9. Drive speed lever
10. Symbols label
11. Remote control lever for the discharge chute
deflector
12. Drive engagement
Product description
The product is a snow thrower that is used to remove
snow from the ground.
10
Contents
Troubleshooting......................................................... 24
Transportation, storage and disposal...................... 26
Technical data.............................................................27
EC Declaration of Conformity....................................28

Introduction

15. Oil fill (for ST 424/427/430 only)
16. Oil drain
17. Starter rope handle
18. Fuel ON/OFF switch (for ST 424/427/430 only)
19. Primer (for ST 424/427/430 only)
20. Continuous track (for ST 424T/427T/430T only)
21. Auger bucket
22. Skid plate
23. Augers
24. Tool for cleaning
25. Discharge chute
26. Discharge chute deflector
27. LED light
Intended use
This product can be used to remove snow from fields,
roads, walkways and driveways. Do not use it on slopes
that are greater than 20°. Do not use the product in
areas where there is much debris, dirt and protruding
stones.
Symbols on the product
Note: If the decals on the product are damaged, contact
the distributor to replace them.
(Fig. 3 )
(Fig. 4 )
(Fig. 5 )
(Fig. 6 )
(Fig. 7 )
(Fig. 8 )
Warning.
Read the operator's manual.
Power on.
Start the engine.
Engine off.
Boost.
891 - 002 -