Philips 9000 Series Manual page 40

40
English
Problem
The shaver is not
fully charged
after I charge it
in SmartClean.
Possible cause
The battery of the
shaver is not
charged sufficiently.
The cleaning
cartridge needs to
be replaced.
You have used
another cleaning
fluid than the
original Philips
Norelco cleaning
cartridge.
The hole of the
drain of the
cleaning cartridge is
blocked.
You have not
placed the shaver in
SmartClean
properly, so there is
no electrical
connection
between
SmartClean and the
shaver.
Solution
If the battery of the shaver
is not charged sufficiently,
the SmartClean may not
work properly. The shaver
needs to be able to switch
on briefly during the rinsing
phase. Charge the shaver
for a short time before you
use the SmartClean to
clean your shaver.
Replace the cleaning
cartridge (see 'Replacing
the cartridge of the
SmartClean system').
Only use the original
Philips Norelco cleaning
cartridge.
Remove the cartridge from
the SmartClean and push
the hairs down the drain
with a toothpick.
Press down the top cap
('click') to ensure a proper
connection between the
shaver and SmartClean.