Table of Contents
Advertisement
1-3. SCSI Setup
This section describes how to set the SCSI ID and SCSI termination on the MAV-70XGI menu.
Procedure
1. Open the "Service: Boards screen" menu. (Refer to the MAV-70XGI Operation Manual.)
Exit
Service : Boards Slot 7 SY MAIN
>Select
-1- -2- -3- -4- -5- -6- *7* -8-
EXT232C
Rdy Rdy Non Non Rdy Rdy Rdy Rdy
2. Select "Select" using the
is inserted using the
> Exit
Service : Boards Slot 5 SCSI
: [1]
SCSI ID
TERMINATOR
: [OFF]
3. Select "SCSI ID" using the
buttons. Then press the [ENTER] button.
n
Perform a setting other than ones of other SCSI equipment connected to the same Gateway.
4. Select "TERMINATOR" using the
buttons. Then press the [ENTER] button.
and
n
Set "ON" only when either of two SCSI connectors is connected.
5. Select "Exit" using the
BKMA-7045
and
buttons and select the slot number into which the BKMA-7045
buttons. Then press the [ENTER] button.
and
and
buttons and select the SCSI ID using the
and
buttons and select either "ON" or "OFF" using the
buttons and press the [ENTER] button.
and
1-3. SCSI Setup
and
1-3 (E)
Advertisement
Table of Contents
