Table of Contents
Advertisement
All manuals and user guides at all-guides.com
DirectCD
TM
v2.5b(s)
Location and Function of Controls
Front Panel
1. Headphone Jack
2. Volume Control
3. Emergency Eject Hole
4. Stop/Eject Button
5. Disc Tray
Rear Panel
1. Digital Audio Output Connector
2. Analog Audio Output Connector
3. Jumper Connector
4. IDE Interface Connector
5. Power Connector
5
1
2
1 2 3
This jumper determines whether the drive is configured as a master or slave.
Changing the master-slave configuration takes effect after power-on reset.
Connect to the IDE (Integrated Device Electronics) Interface using a 40-pin
flat IDE cable.
NOTE : Do not connect or disconnect the cable when the power is on, as this
could cause a short circuit and damage the system. Always turn the power
OFF when connecting or disconnecting the cable.
6
5
3
4
6. Drive activity indicators
Two colored LEDs are used to indicate
the operation of CD-R/RW Drive.
(1) Read
The orange LED is displayed when the
spindle motor begins the spin-up operation:
accessing data, reading data, playing
Audio, and opening or closing the tray.
(2) Write
The green LED is used during disc writing
sessions.
4
5
Advertisement
Table of Contents
