Location and Function of Controls
1. Drive activity indicator (Read/Write)
2. Emergency Eject Hole
3. Stop/Eject Button
4. Disc Tray
1. Digital Audio Output Connector
2. Analog Audio Output Connector
3. Jumper Connector
This jumper determines whether the drive is configured as a master or slave.
Changing the master-slave configuration takes effect after power-on reset.
4. IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) Interface using a 40-pin flat IDE
NOTE : Do not connect or disconnect the cable when the power is on, as this could
cause a short circuit and damage the system. Always turn the power OFF when
connecting or disconnecting the cable.
5. Power Connector
1 2 3