Table of Contents
Advertisement
Saving the bathing program
After setting the bathing mode, temperature, (humidity) and bathing time,
the user can save the current setting to the control centre memory slots (1-4).
The control centre indicates this by showing "SAVE PROG" on the display.
The bathing program is saved by pressing the memory slot button, where you
want to save the program (for example, in the image, the program is saved in
memory slot 1). Note that the program that previously was in that memory slot
is overwritten when the new program is saved. If you do not want to save the
program, press OK or wait for about 10 seconds, and the control centre will
automatically move to next phase.
Setting the pre-selection time
The last setting is the pre-selection time. The control centre can be timed to
start at desired point of time up to 23 hours later. The default setting for
pre-selection time is the current time plus 5 minutes.
The upper display of the control centre shows the current pre-selection time
and the lower display shows the current time. If you want the sauna to heat up
immediately after making the settings, set the pre-selection time to match the
current time. The sauna heater will turn on immediately when the OK button
is pressed. You can freely modify the pre-selection time when the control
centre is in pre-selection mode.
A
1
R
2
A
OK
3
4
A
1
R
2
A
OK
3
4
A
1
R
2
A
OK
3
4
12
Advertisement
Table of Contents
