Appliance Operation; Operation Procedure - Polaris EVO 0225 Operating Instructions Manual

Hide thumbs Also See for EVO 0225:
Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 25
Before using the appliance read the instructions thoroughly and follow as indicated.
Before using the appliance for the first time smoke may appear due to lubricant residuals burning the
used for production purposes.

4.1. Operation procedure

The best way to remove foreign smells is to boil water in the multicooker for 30 minutes in temperature mode "Steam
cooking / Варка на пару" with the half-filled bowl.
СТАРТ / START and ПОДОГРЕВ / ОТМЕНА / KEEP WARM / CANCEL operation modes are activated by holding the
touch button for two seconds. While in operation, there is a possibility of clicks sounding due to the relay operation.
This effect is normal and does not indicate an appliance malfunction.
• Carefully hold the lid when oening.
1.
Open the
• Make sure ensure that internal and external appliance parts are clean and free of packaging.
appliance lid
• Remove the bowl from the multicooker.
58
by pressing the
• Make sure that there are no foreign objects or liquid between the inner bowl and heating surface.
button
2.
Place the
Strictly follow the recipe and instruction in the programs description section. Attention!
ingrediants into
In programs "Fry / Жарка", «Oil fry / Жарка в масле» and "Pasta / Паста" place the food into the
the bowl
bowl after reaching the working temperature only.
The multicooker will give off a sound signal unless it was disabled before (см. п. 4.6.), when reaching
the working temperature, then you can put the food.
3.
Insert the
• Make that the bowl is correctly installed on the heating element.
• Slightly turn the inner bowl in the multicooker from side to side until it assumes the proper position
bowl into the
multicooker
on the heating surface.
4.
The appliance
• Recommendations regarding the lid proper position are given in the description of each cooking
lid may remain
program.
closed or open
Attention!
depending on
If the lid is not in proper position, it might not turn out as well.
the cooking
program and
recommendations
of the recipes.

4. APPLIANCE OPERATION

5. Plug the
• Do not connect the multicooker if the recommendations above are not properly followed.
multicooker
• Turn the appliance on, the display illumination will light up, and the "START / СТАРТ" touch
into the mains
button indicator will start blinking.
socket
Attention!
Parameters of the power mains should correspond to the appliance specifications (see
sec. 10 «Specifications»).
• Each successive pressing the "MENU / МЕНЮ" touch button selects the next program
6. Press the
"MENU /
from the menu list.
• The name of program on the display will light up.
МЕНЮ"
• The program name and timer showing default cooking time will start blinking.
touch button
• The display will show the default temperature only programs in which adjusting
and select a
program
temperature is available.
7. Adjust time
• By pressing the "
" and "
according to the
• The display timer and program name will blink while being set.
recipe
• Time may vary within the range according to the coking program.
• Time increment is variable.
• The maximum operating time for the multistep program «Мультиповар Plus» - 12 hours.
8. Adjust the
• Press the "TEMPERATURE / TIME / ТЕМПЕРАТУРА / ВРЕМЯ" touch button to switch to
cooking
adjusting temperature.
temperature
• The default temperature as also program selected sign will light up and start blinking.
according to the
• By pressing the"
" and "
recipe.
• The temperature may vary within the range according to the cooking program.
Changing
• Temperature increment is variable:
temperature
− 5 °С within the range 30 to 90 °С;
− 2 °С- 90 to 110 °С;
mode is only
− 10 °С -110 to 160 °С.
available for
• The temperature in the program «Мультиповар Plus» may vary in the 30 to 160°С, and to
the programs
«Fry / Жарка»,
170°С in the program «Oil fry / Жарка в масле».
If you need to pause the cooking, you can program a step with a temperature 0°С (i.e. without KEEP
«Oil fry / Жарка
WARMing). At this step, you can remove the bowl from the multicooker. If this pause is set for the
в масле» and
purpose of removing the bowl or adding / removing ingredients, a pause length should be selected that
«Мультиповар
is large enough to perform all required actions before starting the next step.
Plus»
" touch buttons adjust the cooking time.
" adjust the cooking temperature.
59

Advertisement

Table of Contents
loading

Table of Contents