Quick Setup Guide - Sony Trinitron GDM-C520 Operating Instructions Manual

Rear of Display
2 1
AC IN
1 to HD15
1
Connect the power cord to the GDM-C520 display.
Press the power button on the front of the display to verify that the display powers up.
2
Connect the HD15 connector that is on one end of the Artisan
to an HD15 port on the rear of the display.
3
Connect and secure the USB connector on the other end of the Artisan
Signal Cable to a USB port on the back of your computer.
4
Connect the HD15 connector to the HD15 port on the back of your computer.
7
6
Hook and Loop tabs
6
Unfold the hood.
7 Attach the hook and loop pads found in the Accessory Kit to the underside
of the display hood, as shown above.
8
Remove the liners protecting the adhesive on each hook and loop tab.
© 2002 Sony Corporation
TM
Artisan Color Reference System

Quick Setup Guide

3
2
to USB port
to HD15 port
TM
Artisan Signal
Cable
(Supplied)
port
4
TM Signal Cable
TM
8
Rear of Computer
USB port
5
9
9
10
5
jack
Connect the USB end of the Artisan TM Sensor to an open USB port on
your computer, or connected to it through a peripheral device such as a
keyboard or USB hub.
Note: Make sure that the sensor can be placed easily over the
center of your display screen, without stretching the sensor's
cord.
Wrap the hood around the display. Make sure that the hood is evenly
aligned.
Fold the adhesive tabs inward the display, pressing firmly to
ensure proper adhesion of the tabs to the underside of the display.
4-092-902-11
Artisan TM Color
Reference Sensor
10