ATCOM A20 LTE Quick Start Manual page 11

A2X(W) Quick Start Guide
3.4. If the PIN code is enabled on the SIM card, after entering the standby interface, you will
be asked to enter the PIN code.
According to the network service provide requirement: you need to enter the correct PIN
code within three times. Otherwise, the card will be automatically locked and the PUK
code will be prompted to unlock.
3.5. If the SIM card need input APN code, you can press Menu → LTE setting → APN
setting, choose "Enable" custom APN, and press ↓button to input APN account info.
4. Connection
4.1. Connect to LTE network:
If enable LTE setting, A20 LTE get service network.
(Note: The A20 LTE phone can communicate with other devices through the LTE data
acquisition network. The acquired LTE data network is the public network of the carrier. At
this time, the phone web interface cannot be accessed.)
The topology is as follows:
4.1.1. Press Menu → LTE Setting, enable LTE feature
4.1.2. After enable LTE, press ↓ key, you can see Network service, Network type,
Signal strength and IMSI.
4.2. Connect to network cable:
A20 LTE if connected to network via LAN port, then under the Bridge mode, other devices
(Laptop, IP phone) are able to access network via the phone PC port.
11