Supermicro X11SDD-8C-F User Manual page 66

Super X11SDD-8C/18C-F User's Manual
Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disabled and Enabled.
Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disabled and Enabled.
SATA Device Type
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
SATA Port 4
This item displays the information detected on the installed SATA drive on the particular
SATA port.
Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disabled and Enabled.
Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disabled and Enabled.
SATA Device Type
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
sSATA Configuration

When this submenu is selected, the AMI BIOS automatically detects the presence of the
SATA devices that are supported by the Intel PCH chipset and displays the following items:
sSATA Controller
Use this feature to enable or disable the onboard SATA controller supported by the Intel PCH
chipset. The options are Enable and Disable.
Configure sSATA as
Select AHCI to configure a SATA drive specified by the user as an AHCI drive. Select RAID
to configure a SATA drive specified by the user as a RAID drive. The options are AHCI and
RAID.
66