Filter Slide; Control Via Usb - SCHOTT KL 2500 LED User Manual

KL 2500 LED – Operating instructions

2.5 Filter slide

The KL 2500 LED has a filter slide (8) which can be fitted with an insert filter from the filter set
(available as accessory).
When operating the light source the filter slide must always be engaged in one of the end positions
or in the rest position. This is the only way to guarantee optimum air cooling of the light source.
Safety information:
WARNING !
Operating the light source with the filter slide in an intermediate position can cause damage to the
slide.
Fitting the filter slide
Please ensure the filter slide (8) has cooled down before fitting the insert filter.
Completely pull out the filter slide (8) from the light source so that the label is legible. Insert the filter
with 28 mm diameter using lint-free gloves from top right behind the two retaining lugs and fix it with
slight pressure. The filter is then lying flat inside the holder.
To remove easily bend the bracket to the left and remove the filter with gloves.
If you wish to operate the light source for a short time without a filter then only pull the slide out to
the first rest position. In this position the filter is still in the light source, but no longer in the light path.

3. Control via USB

Your KL 2500 LED comes with a USB port making it possible to be controlled by computer using the
USB connecting cable supplied. SCHOTT provides demo software (see Point 3.2) to demonstrate
the control function, installable on request at below mentioned address. It is also possible to
integrate the light source controlling in individual software by linking the corresponding protocol
commands (see Point 3.3.).
8/12