Step 3: Attaching The Monitor Support Arms - Insignia NS-PMM6230 Assembly Manual

STEP 3: Attaching the monitor support arms

As you decide where to position the monitor support arms, remember the tops of the monitors should be level with your
eyes.
Note: You need a Phillips screwdriver for this step.
1 Make sure that the wider opening on one of the arm support rings (5) is facing up, then place the ring on the support
tube at the level you want the mounting plate and support arm. Use a Phillips screwdriver to tighten the pre-installed
screw in the ring to hold the ring in place.
2 Slide one of the monitor plate and support arm assemblies (1 or 4) onto the support tube, making sure that the curved
portions of the arm are pointed down. Tighten the arm knob to secure the arm.
3 Slide the fixed ring (2) onto the support tube just above the arm support you installed in step 2. Use a Phillips
screwdriver to tighten the screw in the ring to hold the ring in place.
www.insigniaproducts.com
NS-PMM6230
11