EXPLANATORY DIAGRAM ____________________ 16 avoid injuries and damage to the device. THE TITAN PLUG ‘N‘ SPRAY SYSTEM ___________ 16 Indicates tips for use and other particularly useful information. 3.1 Disassembly of the spray gun __________________ 16...
Focus 500 SAFETY REGULATIONS b) Wear personal safety equipment and always wear SAFETY REGULATIONS safety goggles. Wearing personal protective equipment, such as dust mask, non-slip safety shoes, safety helmet or ear protection, depending on the type of power tools, All local safety regulations in force must be observed.
Page 8
Focus 500 SAFETY REGULATIONS 5. Service 4. Warning: When working with the paint spraying system both indoors and outdoors, ensure that no a) Have your tool repaired only by qualified specialist solvent-based vapours can form within the area of personnel and only with original spare parts. This the paint spraying system.
THE TITAN PLUG ‘N‘ SPRAY SYSTEM With the Titan PLUG ‘N‘ SPRAY System, the front part of the gun (spray attachment) can be replaced quickly and easily. This enables a rapid material change without cleaning, and ensures that the right tool is available for every material and applica- tion.
All settings necessary for operation (e.g. material volume) can be conveniently made, directly on the gun. Field of application The Focus 500 is designed for smaller to medium-sized pro- jects, i.e. for surfaces of a maximum of 50 m². COATING MATERIAL...
The fixture for the carrying strap can be mounted control (Fig. 5, 1). to the other side of the Focus 500 if this is preferred. Do this by unscrewing the two large screws (fig. 8, SETTING THE AMOUNT OF AIR (FIG. 6) 1).
(fig. 24). 5. Connect spray attachment and gun handle. (Fig. 2) 2. Put the Focus 500 and accessories inside the case as shown 6. Pull the trigger to rinse the spray attachment. in fig. 25 and secure with elastic straps.
Focus 500 MAINTENANCE with cleaning brush. (Fig. 12) MAINTENANCE CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray gun 13.1 AIR FILTER with metal objects. The ventilation hose and diaphragm are only solvent-resistant Attention! Never operate the device with to a limited extent.
Focus 500 CORRECTION OF MALFUNCTIONS Warning • If the supply cord of this appliance is damaged, it must only Should it be necessary to exchange the fuse in the plug only use fuses approved by ASTA in accordance with BS 1362.
Focus 500 ACCESSORIES AND SPARE PARTS MALFUNCTION CAUSE REMEDY • • Atomisation too coarse Material volume too large Reduce volume • • Nozzle contaminated Clean • • Viscosity of coating material too high Dilute further • • Too little pressure build-up in...
Focus 500 SPARE PARTS AND ACCESSORIES 15.2 SPARE PARTS FOCUS 500 (FIG. 26) ORDER NO. POS. DESIGNATION 2343 946 Cover of air filter compartment 2343 947 Air filter (3 pcs.) 2343 948 Fixture for shoulder strap (incl. screws) 2344 464...
DISCLAIMS ANY AND ALL IMPLIED WARRANTIES INCLUDING, BUT NOT LIMITED TO, THOSE OF MERCHANTABILITY AND FIT- Titan or one of our dealers will take back your used Titan waste NESS FOR A PARTICULAR PURPOSE, TO THE EXTENT PERMIT- electrical or electronic equipment and will dispose of it for you TED BY LAW.
Need help?
Do you have a question about the Focus 500 and is the answer not in the manual?
Questions and answers