Advertisement
CONNECTION DIAGRAM / Anschlussdiagramm
ENGLISH
IMPORTANT NOTE: Usually both OEM plugs of the vehicle must be connected („plug and play") to the ESX Naviceiver, without the need to
change the PIN configuration in any way. But please check the exact pin assignment, especially „ACC", „BATT" and „CANL / CANH" of the
original plug for its correctness. Under certain circumstances, e.g. vehicles with special equipment such as active sound systems or OEM
navigation systems, the pin assignment may differ respectively and the installation is not possible.
FUSE: In case of a defect, the fuse must be replaced with a fuse of the same value (10A). Eliminate the cause of the short circuit
before replacing the defective fuse.
ASSIGNMENT OF THE ACCESSORY CONNECTORS
5
Audio / Video / AV Inputs G71-AUD0119
Name
Connector/Color
AV1-L-IN
RCA white
AV1-R-IN
RCA red
AV1-V-IN
RCA yellow
AV2/TV-L-IN
RCA white
AV2/TV-R-IN
RCA red
AV2/TV-V-IN
RCA yellow
AV3/AUX1-L-IN
RCA white
AV3/AUX1-R-IN
RCA red
AV3-V-IN/VIDEO
RCA yellow
+12V OUT
yellow
GND
black
TV-CONT-OUT
brown
BRAKE IN
pink
6
Audio Outputs with Remote Turn On G71-MNV0010
Name
Connector/Color
FL-OUT
RCA white
FR-OUT
RCA red
RL-OUT
RCA white
RR-OUT
RCA red
SUBWOOFER-OUT
RCA brown
CENTER-OUT
RCA yellow
AMP-CONT-OUT
green
7
Various System Connections G71-WHE0063
Name
Connector/Color
Uart/+5V OUT
black
SWC1IN
red-white
SWC2IN
green-white
ILL IN
orange
ANT-POWER OUT
yellow
Function
AV Audio left in AV/TV menu
AV Audio right in AV/TV menu
AV Video in AV/TV menu
AV2 Audio left in AV/TV menu
AV2 Audio right in AV/TV menu
AV2 Video in AV/TV menu
AV3 Audio left in AV/TV menu
AV3 Audio right in AV/TV menu
AV3 Video in AV/TV menu
12V Output
Power supply for external devices such as DVB-T tuners.
Maximum current consumption 500 mA.
Ground wire to +12V OUT
Control cable for special ESX devices, please do not use.
Connect to the parking brake signal to the device.
The cable provides a ground signal when the parking brake is operated.
Function
Pre-amplifier output front left
Pre-amplifier output front right
Pre-amplifier output rear left
Pre-amplifier output rear right
Pre-amplifier output Subwoofer (Mono)
Pre-amplifier output Center
Remote Turn On output
12V output to turn on an external amplifier.
Maximum current consumption 500 mA.
Function
Reserved, please do not use!
Please do not use - SWC1IN is used by OEM plug
Please do not use - SWC2IN is used by OEM plug
Please do not use - ILL IN is used by OEM plug
12V output for FM antenna amplifiers. Attention! The power supply is only active
while the FM function of the device is activated. Max. Current consumption 100 mA.
7
Advertisement
