LaserLiner PowerPlane-Laser 3D Manual page 12

4
Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out
levelling at great distances or when the laser
lines are no longer visible. To work with a laser
receiver, switch the line laser to hand-held
receiver mode by keeping button 7 (hand-
held receiver mode on / off) pressed. The laser
lines will now pulsate with high frequency,
making the laser lines darker. The laser receiver
can detect these pulsating laser lines.
!
Observe the laser receiver's operating
instructions for line lasers.
Due to the special optics required to generate a continuous 360° laser
!
line, the underlying technology may cause differences in brightness in
different areas of the line. This may lead to different ranges in hand
receiver mode.
5
Slope mode
Do not release the
transport restraint,
set slide switch to
the mid-position
and select the lasers
with the selector
switch. Sloping planes
and tilts can now be
measured. In this mode, the laser lines no longer align automatically. This is
signalised by the laser lines flashing. In addition, the LED light (8) remains red.
12
EN
LASER LASER LASER LASER