Konica Minolta PULSOX-300 Short Form Instruction Manual page 17

2 Insert the battery into the battery compartment according to the polar-
ity mark( ) shown on the rear of the instrument.
This instrument requires one AAA-size battery.
◆
3 Turn the battery cover counter-clockwise approximately 90 degrees to
close it.
Introduction of a new mechanism locks the cover automatically when
◆
it is closed.
3. MEASUREMENT
1) Starting the Measurement
1 Attach the probe to a finger of an adult patient.
2 Press the Power button.
The Power is switched ON, all the elements on the display are
●
displayed for about 2 seconds, and then the display changes to the
measurement display.
Until the measurement value has been calculated and displayed,
◆
"---" will be displayed as the values of the oxygen saturation (SpO
and the pulse rate.
2) Reading the display
When the instrument is turned ON, all the elements of the LED will light
up.
The pulse level, pulse rate and SpO
surement.
3) Ending the Measurement
Press the Power button, the measurement is finished and the Power is
off.
About Auto Power-Off function
The instrument has an auto power-off function that operates indepen-
dently. If no probe is connected to the PULSOX ("C" blinks) or no probe
is attached to the patient ("L" blinks) continuously for more than 2 min-
utes, the Power is automatically switched off.
value are displayed during mea-
2
)
2
E 3