Konica Minolta PULSOX-300 Short Form Instruction Manual page 15

English
Contents:
1. Description of the Analyzer/parts
2. Preparation
3. Measurement
4. Notes on Use
5. Error Messages
6. Safety Precautions
1. DESCRIPTION OF THE ANALYZER / PARTS
For the following descriptions, please refer to the diagrams on the inside
back cover of this instruction manual. See A1 for names of parts, A2 for
Display, and A3 for Probes.
A1 A 1 Power Button (to swich ON/OFF)
A 2 LED (to display the measurement value and messages)
B 3 Probe connector (to connect the probe)
4 Battery cover (to lock the chamber)
5 Wrist band (to attach the instrument on the wrist)
A2 6 Pulse rate (P.R.)
7 SpO
8 Blink when Battery capacity down
9 Pulse level Meter
A3 1 Finger Clip Probe SR-5C
2 Spot Check Probe SP-5C
3 Monitor Probe
4 Personal Probe
5 Extension Cable
Calculation Method for Displayed Values
<Pulse level meter>
The pulse level meter displays the transmitted light amount ratio calculated by
the following equation. The pulse level is indicated in eight levels (0 to 15%, full
scale if over 10%).
Pulse level (%) =
<Oxygen saturation (SpO
Updates the moving average of the oxygen saturation over the last 12 seconds
at one-second intervals.
<Pulse rate (P.R.)>
Updates the moving average of the last 8 pulse rates at one-second intervals.
value
2
LM-5C
SD-5C
EC-300
Transmitted light amount that varies due to the pulse
Transmitted light amount that does not vary due to the pulse
)>
2
Page E1
Page E2
Page E3
Page E4
Page E5
Page E9
x 100
E 1