Cleaning And Care - Klarstein 10028097 Manual

CLEANING AND CARE

Self-Clean Mode
The self-clean mode should be put into operation before you use your ice maker for
the first time and/or if there has been a long period without use. Three Icons as Large,
Medium and small Icons will be on at the same time when the ice maker is in self-clean
mode.
Stage 1
• Add equal parts of water and vinegar (1:1) to the ice maker's reservoir.
• With the stand-by mode, keep pressing ON/OFF button at least 5 seconds
to activate the self-clean mode. Please note that self-clean mode will start
automatically after "Beep" sound.
• During the self clean mode, the upper water bucket is filled and dumped. The pump
will remain in continuous operation as it feeds water to the bucket and evaporator
coils. This cycle will continuous for five times.
• Upon completion, the unit automatically changes to stand-by mode.
Stage 2
• Drain the cleaning solution from the internal reservoir by removing the rear drain
cap and plug.
• Add fresh water to the Max. permit water volume line.
• With the stand-by mode, keep pressing ON/OFF button at least 5 seconds to
activate the self-clean mode again which will now act as a rinse.
• Upon completion of this final stage of the self clean process, the unit automatically
changes to stand-by mode. Proceed to drain the water from the internal reservoir by
removing the rear drain cap and plug. Leave the lid on the ice maker open to allow
it to air dry.
Note: Please note if there is a water shortage during Self-cleaning mode, the unit will
automatically go into stand-by mode; If water bucket is fail to turn over, icon
be on, you need to long press ON/OFF button for more than 5 seconds to release
self-cleaning mode to change for other operations.
will
EN
19