Maintaining And Cleaning Magic Watch; Troubleshooting - Waeco MAGIC WATCH MWE-1000-4FM Installation And Operating Manual

_MWE-1000-4FM.book Seite 47 Dienstag, 9. August 2005 11:30 11
magic watch
9 Maintaining and cleaning
MAGIC WATCH
Caution
Do not use sharp or hard objects to clean the device as these may
damage the sensors.
➤ Clean the sensors with a damp cloth from time to time.
10

Troubleshooting

The device indicates no function.
The cables to the reversing light are not connected or are not properly
connected.
The plugs for the sensors are not connected or are not properly plugged into
the control box.
➤ Check the plugs, and plug them in so that they latch in place.
Defective sensor display
Defective sensors are indicated as follows:
Fault
Sensor 1 (d, page 7)
is not detected or is
defective
Sensor 2 (d, page 7)
is not detected or is
defective
Sensor 3 (d, page 7)
is not detected or is
defective

Maintaining and cleaning MAGIC WATCH

Display
In the distance display (k 2, page 9) the
number "1" flashes three times within three
seconds. MAGIC WATCH then works normally.
In the distance display (k 2, page 9) the
number "2" flashes three times within three
seconds. MAGIC WATCH then works normally.
In the distance display (k 2, page 9) the
number "3" flashes three times within three
seconds. MAGIC WATCH then works normally.
47