Oki C9600 Series Disassembly & Reassembly Procedures page 21

17.1. Unplug 17
connectors and
remove four
screws.
NOTE: Prior to unplugging
all of the wiring
connectors from the
engine controller board
make note of the wire
harness routing. Where
do the various cables/
harnesses enter the card
cage, etc.?
It's easier to note this
now, when the machine is
fresh, than to try and
figure it out when you're
rushing to reassemble the
unit.
17.2. Push the Engine
Board slightly to
the left - pull the
bottom of the
board out then
remove entire
board.
NOTE: If replacing a failed
Engine Board, the
socketed double eprom
must be retained and
inserted into the new
Engine Board.
18. Remove the Plate Shield
Box Assy. (Card Cage)
18.1. Remove 1 screw
to release the
Plate Clamp HCB
(LED Head Cable
clamp). Slide the
white plastic
bracket outward to
release it from the
Card Cage.
18