Step 7: Connecting To The Console Port To Manage The Switch (Initial Configuration); Figure 3-3. Installing A Gigabit Ethernet Fiber Module Into An Fsm7328S - NETGEAR ProSafe FSM7328S Operating Instructions Manual

To install additional Gigabit Ethernet module, repeat this procedure

Step 7: Connecting to the Console Port to Manage the Switch (initial configuration)

To learn the IP address, you must first access the Command Line management via the console interface.
After you power-up the switch for the first time, you can connect to it using a VT100/ANSI terminal or a PC,
Apple Macintosh, or UNIX workstation that is directly connected to the switch's console port.
To connect a console to the switch:
1. Connect a VT100/ANSI terminal or a PC, Apple Macintosh, or UNIX workstation to the switch's console
port, labeled Console, using the null-modem cable supplied with the switch. The supplied null-modem
cable has 9-pin connectors on each end.
2. If you attached a PC, Apple Macintosh, or UNIX workstation, start a terminal-emulation program.
Microsoft Windows users can use HyperTerminal, which comes with the Windows operating
systems.
Macintosh users can use ZTerm.
UNIX users can use a terminal emulator such as TIP.
3. Configure the terminal-emulation program to use the following settings:
Baud rate: 9,600 bps
Data bits: 8
Parity: none
Stop bit: 1
Flow control: none

Figure 3-3. Installing a Gigabit Ethernet fiber Module into an FSM7328S

Page 16 of 24