Robot Coupe CMP 400 V.V. Manual page 7

• Removing the bell from the tube
- Unplug the power mixer.
- Turn the bell in the direction of the arrow
next figure) to separate the bell lug
tube lug .
F
- Remove the bell.
If jammed, turn the blades inside the bell in the
direction of the arrow to loosen them from the
2
drive shaft.
• Removing the blades
- Unplug the power mixer then, hold the blades
with the provided blade-locking tool.
- Using the blade-locking tool, unscrew the drive
coupling then remove the blade for easy cleaning.
BLADE LOCKING
BLADES WITH WATERTIGHT SEALS
BELL
DRIVE COUPLING
BLADE REMOVAL
8
- WHISK
• Attaching the whisk holder to the motor unit
(only for CMP Combi)
(see
1
E from the
- Unplug the power mixer.
- Align the flat side
whisk holder with the catch
aluminum casing.
- Insert the conical part
the aluminum casing.
- Turn the whisk holder in the direction of the arrow
(see figure) until it is snugly locked into place.
• Removing the casing
- Unplug the power mixer.
- Turn the whisk holder in the opposite direction
from that used to attach it.
- When it will go no further, remove the whisk
holder from the aluminum casing.
A
of the conical part C of the
B
on the inside of the
C of the whisk holder into
• Fitting the whisk into the whisk holder
C
D
A
- Grasp the holder in one hand.
- With the other hand, take the first whisk and insert
A
B
the shaft into the bore of the whisk holder
drive shaft. Make sure the drive lugs
properly aligned with the notches.
- As you push the whisk into the holder drive shaft
C
, rotate it slightly in order to slide the drive lugs
D
into the notches of the drive shaft
locking the whisk into place inside the shaft.
- To check that the whisk is properly fixed inside the
shaft C , gently pull the metal wires.
- Repeat this procedure with the second whisk. If
you cannot push it in properly, remove it, rotate it
90° and start again.
B
E
D
are
C , thereby