Wiring; Applying Power; Testing The System And Pc5502Z2 Keypads - DSC PC5502Z2 Installation Manual

Hide thumbs Also See for PC5502Z2:

Table of Contents

2.3 Wiring

1. Before beginning to wire the unit, ensure that all power (AC transformer and bat-

tery) is disconnected from the control panel.

2. Connect the four Keybus wires from the con-

trol panel (red, black, yellow and green) to

the keypad terminals (R B Y G). See the dia-

gram at right:

3. You can connect two devices - such as door

contacts - to the Z1 and Z2 terminals of the

PC5502Z2. To connect the zone, run one

wire from the device to the Z terminal and

the other wire from the device to the B

(black) terminal. For powered devices, run the

red wire to the R (positive) terminal and the

black wire to the B (negative) terminal.

When using end of line supervision, connect

the zone according to one of the configura-

tions outlined in your system's Installation

Manual.

NOTE: The PC5502Z2 zones will follow the end-of-line supervision option

selected for the main panel. Please refer to your panel's Installation Manual for

more information.

Once you have completed all the wiring, apply power to the control panel:

1. Connect the battery leads to the battery

2. Connect the AC transformer.

For more information on control panel power specifications, see the control panel Instal-

lation Manual.

NOTE: Do not connect the power until all wiring is complete.

You cannot perform a system test from the PC5502Z2 keypad. To conduct a system test

at the system keypad, please refer to your system's Installation Manual and Instruction

Manual.

Now that you have connected the PC5502Z2, you will need to enroll it with the control

panel. Please see section 3 for instructions.

Table of Contents