Assembling The Curved Handle; Operation; Hanging On/Removing The Grass Bag; Level Gauge - FLORABEST FRM 1800 C3 Translation Of The Original Instructions

Assembling the Curved
Handle
For a simple holmm installation, select
cutting height 20 mm (see „Adjusting
the cutting height").
1. Remove the two pre-installed
B
butterfly nuts (2a) from the lawn-
mower housing (7). Insert the
lower bar (3) into the slot on the
lawnmower housing (7).
2. Fix the bottom bar (3) using the
two screws and butterfly nuts
(2a).
3. Tighten the loop handle (1) with
C
the enclosed carriage bolts (16)
and two locking levers for beam
attachment with washer (2b) to
the lower beam (3).
4. Clip the cable hooks (10) into
the bar (3) and the handle (1) to
fasten the cable.
When both wing nuts are loosened,
the curved handle can be folded
down for storing the equipment.
Ensure that the power cable is not
caught.

Operation

Hanging On/Removing the
Grass Bag
1. To hang on the grass bag (4),
D
lift the collision guard (9) and
hang on the grass bag. Fold the
collision guard (9) onto the grass
bag (4). It holds the grass bag in
the correct position.
2. To remove the grass bag (4), lift
the collision guard (9) and detach
the grass bag. Fold the collision
guard (9) back onto the mower
housing.
Do not work with the lawn-
mower without the collision
guard or lawn box. There is
a risk of injury.
E

Level gauge

The level gauge (17) is located on the side
of the grass catcher (4).
Flap (17) open:
grass catcher (4) empty
Flap (17) closed:
grass catcher (4) full
The level indicator (17) works when
the device is in operation.

Emptying the Grass Bag

To empty the grass collection bag, also use
the bottom bag handle (4).

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
F
1. Hold the cut height adjusting
lever (5) and guide it past the
indent to the desired cut height
setting.
2. The handle (8) may be used
to help, in order to prevent to
mower rolling away.
GB IE NI
13