Table of Contents
Advertisement
Figure 3-17. Flatness Correction Equipment Setup
Connect the equipment as shown in Figure 3-17:
Select the
NNNNNNNNNNNNNNNNN
menu so that the
Adjust the signal generator AMPLITUDE to a level near the center of your power sensor
range.
If the RF output is currently turned o , press the
Select the register where the
atness correction data is to be stored.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Select the external power meter to be used during the
atness correction routine.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
NNNNNNNNNNNNNNNNNNNNNNN
Enter the power meter address into the signal generator so that the instrument can
address the power meter during the
atness correction routine.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
4
5 4
5
2
3
NNNNNNNNNNNNNNNNN
Select the start frequency for data collection by pressing the
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
softkey.
where X.XXXXXXXXX is the current start frequency.
Enter the desired start frequency.
3-36
Generating Signals
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
NNNNNNNNNNNNNNNNN
function is selected.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
softkey to turn it on.
(
key and then the
4
5
Advertisement
Table of Contents
