Husqvarna 520iRX Operator's Manual page 26

To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.
To sweep the grass
The airflow from the rotating trimmer cord can be used
to remove cut grass from an area.
1. Hold the trimmer head and its cord parallel to the
ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer cord
to prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.
To clear grass with a grass blade
1. Stand firmly with your feet apart.
2. Let the support cup rest lightly against the ground.
Do this to protect the blade from hitting the ground.
26
3. Use a sideway swing movement from right to left to
use the clear stroke and let the left side of the blade
(between 8 and 12 o'clock) do the cutting.
4. Angle the the blade to the left when you clear grass.
Note: The grass will collect in a line, which makes it
easier to collect.
5. Use a sideway swing movement from left to right for
the return stroke.
6. Do the work rhythmically.
7. Move forward and stand firmly again.
8. Stop the engine.
9. Remove the product from the clip on the harness.
10. Put the product on the ground.
11. Collect the cut material.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the start/stop button until the green LED is off.
3. Push the release buttons on the battery and pull the
battery out.
To set the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar clockwise until the throttle handle
touches the battery.
757 - 001 - 24.10.2018