Adjusting 45°And 90°Positive Stops; Aligning Blade Guard Splitter Or Riving Knife With Blade - HARVEY C200 Series Operating Instructions Manual

If an adjustment is necessary, loosen the screws
which are fixed to the table (as indicated by the
pointing arrows) and make the needed adjustment
until both measurements are equal or less than 0.2
mm. and retighten the screws. Refer to Fig. 24.
Fig. 23
Fig. 24
6.4 Adjusting 45°and 90°Positive Stops
The tilt mechanism has adjustable stops for vertical
and 45°. The machine comes factory-set but should
adjustment be required, loosen and adjust the stops
and retighten the stops. Refer to Fig. 25.
Fig. 25
6.5 Aligning Blade Guard Splitter or Riving
Knife with Blade
The blade guard splitter and/or riving knife must be
aligned with the blade. If not properly aligned, the
splitter/riving knife will force the workpiece sideways
during the cut, increasing risk of kickback. Place a
straightedge against the blade and the splitter or
riving knife and check for parallelism. If an
adjustment is needed, the mounting position can be
adjusted into alignment with the blade using the
adjustment set screws (A) Refer to Fig. 26.
1. Disconect saw from power source.
2. Remove the table insert.
3. Loosen the upper and lower cap screws (B), then
adjust the 4 set screws in or out until the alignment
is perfectly parallel.
4. Reinstall the table insert.
Fig. 26
17