Front Fascia Fitting - Baxi 741 Installer's Manual

INSTALLER GUIDE
2. Fit the ceramic side walls
against the side faces of the
burner compartment. The
bottom edges of the walls
should rest in the ledges at
the sides of the firebox.
Slide them in from the front
and ensure that they touch
the rear wall. Be careful not
to damage the edges of the
side walls (See figure 24).
Figure 24. Ceramic side walls installation

12. FRONT FASCIA FITTING

1. The fascia is supplied in three pieces.
Carefully remove the three fascia pieces from
the packaging. Remove any protective film.
2. The magnets used to locate each fascia trim
should already be positioned on the rear of each
trim. Each fascia trim should have two magnets.
If the magnets are not fitted then locate one
magnet centrally at each end of the trims.
3. Locate the side fascia trims as in figure 25.
4. Locate the top fascia trim as in figure 25.
5. Fit the burner baffle to the front flanges of the
burner. To do this, place the baffle against the
front flanges of the burner and lower into
Figure 25. Fascia location
position. The return edges on the
rear of the baffle should slot over the
front flanges of the burner (See
figure 26).
Figure 26. Fitting the burner baffle
Page 24