Table of Contents
Advertisement
8. PREPARING APPLIANCE FOR INSTALLATION
8.1 Appliance preparation.
1. Remove any transit tape and
packing and inspect for any evidence
of mishandling which might affect the
performance. Each unit is flame
tested before it leaves the factory and
as a result there may be slight
discolouration around the burner
ports.
2. Detach the burner unit from the
hotbox by removing two screws (See
figure 8). Lift the burner unit clear.
3. It is important that the grommet
supplied in the loose parts pack is fitted to
the hole in the rear of the hotbox.
8.2 Fitting the fascia.
1. The fascia is supplied in three pieces.
Carefully remove the three pieces from the
packaging. Remove any protective film.
2. The magnets used to locate each trim
should already be positioned on the rear of
each trim. Each trim should have two
magnets. If the magnets are not fitted then
locate one magnet centrally at each end of
the trims.
3. Locate the side trims as in figure 9.
4. Locate the top trim as in figure 9.
INSTALLER GUIDE
Figure 8. Burner attachment points
Page 15
Figure 9. Fitting the fascia
Advertisement
Table of Contents
