Motor Cables And Accessory Kits - Allen-Bradley MPL-A310 Installation Instructions Manual

Motor Cables and Accessory Kits

This section describes accessories that are available for MP-Series low-inertia motors.
Motor Cables
Factory manufactured feedback and power cables are available in standard cable lengths. They
provide the sealing needed to achieve environmental ratings and shield termination.
If you choose to build your own cables, connector kits available for MP-Series small frame
motors are described in the Kinetix Motion Accessories Specifications Technical Data,
publication GMC-TD004.
Shaft Seal Kits
Shaft seals must be lubricated. Lubricant is supplied with the shaft seal kits.
IMPORTANT
Third-party shaft seals are not approved for use with these motors. The use of third-party shaft
seals voids any implied or expressed warranties.
A shaft seal is a barrier that can prevent moisture and particles from entering the motor bearings.
Shaft seals are subject to wear and require periodic inspection and replacement. Replacement is
recommended every 3 months, not to exceed 12 months, depending on use.
Catalog numbers for the motors and corresponding replacement Nitrile–shaft–seal kits are listed
in the table.
Motor Cat. No.
MPL-A310, MPL-B310
MPL-A320, MPL-B320
MPL-A330, MPL-B330
MPL-A420, MPL-B420
MPL-A430, MPL-B430
MPL-A4520, MPL-B4520
MPL-A4530, MPL-B4530
MPL-A4540, MPL-B4540
MPL-A4560, MPL-B4560
MPL-A520, MPL-B520, MPL-A540, MPL-B540,
MPL-A560, MPL-B560
MPL-B580
For instructions on how to install a shaft seal, refer to the Shaft Seal Kit Installation Instructions,
publication 2090-IN012.
MP-Series Low-inertia Servo Motor with 100 mm to 165 mm Frame Size 23
Shaft Seal Kit Cat. No.
MPL-SSN-A3B3
MPL-SSN-A4B4
MPL-SSN-A5B5
MPL-SSN-F165
MPL-SSN-F165-32MM
Rockwell Automation Publication MP-IN001I-EN-P - January 2015