Advertisement
Dalton Park 5pc Dining Set
Step 4:
HARDWARE
PART
10
M6 x 50mm Bolt x 6
Lay the Chair Backrest (E) on a level and protective surface with the threaded inserts facing
●
up.
Attach Side Rails (H) onto the Chair Backrest in place with the end wood dowel fully inserted
●
into the hole without threaded inserts. Make sure the pre-drilled slant holes face inward. In-
sert and screw the M6 x 50mm Bolts (10) with Flat Washers (6) through the slant holes into
the threaded inserts included on Backrest. Loosely tighten the bolts with M4 Allen Wrench
provided.
Fully insert the tenon of Left & Right Side Stretcher (I & J) into the mortises on the Backrest
●
(E) properly. Make sure the Arrow UP stickers are facing in and the slant screw holes on the
stretchers will face floor after assembly. Insert and screw the M4 x 38mm Screws (4) into the
pre-drilled holes underneath the stretcher. Loosely tighten with Phillips Screwdriver.
Repeat the procedure to attach the Front Leg Assembly (G) at opposite end.
●
Note: DO NOT fully tighten all the screws & bolts until the chair been adjust & level all the legs
so that they do not wobble. Once adjusted then go back and tighten while making sure that the
unit remains level.
NEED HELP? For help with assembly or if you are missing a part, please call Whalen Furniture Mfg. Inc. 1-866-942-5362
(8:30 a.m. to 4:30 p.m., PST, Monday - Friday) or e-mail to: parts@whalenfurniture.com.
PART
4
M4 x 38mm Screw x 4
PART
6
M6 Flat Washer x 6
Page 6 of 9
Advertisement
