Table of Contents
Advertisement
3 AB1A Operation
3.1
Operation Modes
The AB1A can be operated in one of the following operation modes:
•
Velocity Mode , in which the motor is driven continuously.
•
Gate Mode , in which the motor is driven at low velocity by
turning the driver output ON and OFF in time intervals defined by
outside TTL signal in an open loop.
•
Step Mode , in which the driver output is turned OFF and ON at
predefined intervals, in order to drive the motor in discrete steps.
3.1.1 Velocity Mode Operation
In this operation mode, the motor is driven continuously by applying the analog
command voltage (± 10 V) using a relevant interface device (joystick or motion
controller).
3.1.2 Step Mode operation
In this operation mode the motor is turned on and off for fixed time intervals
defined in the hardware as follows:
•
ON phase - 1/16 second
•
OFF phase - 0.5 second
The amplitude of the output corresponds to the analog command input value
and thus determines the speed of the motor.
3.1.2.1 Enabling the Step Mode
Enable the Step operation mode, by shorting pin 16 (see Table 8) to the
ground..
3.1.3 Gate Mode Operation
In this operation mode, the motor is driven at low velocity in open loop by turning
the driver output ON and OFF in time intervals defined by an external switching
signal.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
AB1A Driver Box User Manual
AB1A Operation
21
Advertisement
Table of Contents
