Temperature Sensor; Control Module (Relay Board); Replacing The Control Module - Bosch Benchmark Series Service Manual

58300000187895 ARA EN A
5. Holding the terminal plate, pull the bake element outward,
leaving the insulation in place; a putty knife or similar tool may
be useful.
Figure 25 Removing the bake element
6. Install the new element.
7. Bend the access panel upward and secure it with screws.
8. Reconnect the wires to the element terminals.
9. Restore power and test operation.
10. Slide the range back into the cutout, being sure to engage the
anti-tip bracket.
7.9

Temperature Sensor

The PT1000 temperature sensor is in the upper left corner of the
cavity, with two screws securing it. An ohmmeter can be used to
check the resistance of the sensor. Normal ranges (based on cavity
temperature) are shown in Table 7.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
Table 7 Normal resistance readings for temperature sensor
7.10

NOTICE
More than 75% of the control modules returned to the factory are fully
functional. Before diagnosing a bad control module, be sure to
disconnect and reconnect each wire/wire harness.
The control module controls the elements, fans, door locks, lights,
etc., regulate temperatures, and monitor safety functions. The module
is also responsible for communication with other modules, analyzing
sensor data, regulating line voltage, and managing user interface
activities.

7.10.1 Replacing the Control Module

1. Remove power to the range.
2. Slide the range out of the cutout to get access to the rear of
the unit.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges

Control Module (Relay Board)

Page 23 of 36
800 944-2904