Download Print this page

Limiting Values, Recommendations And Precautions - Gigahertz Solutions HF32D Manual

High frequency analyser for frequencies from 800 mhz to 2.5 (3.3) ghz
Hide thumbs Also See for HF32D:

Advertisement

Available languages

Available languages

M a d e in G e r m a n y
The ratio of minimum to maximum load of a cellular phone base
station usually is 1 to 4. At the time of measurement one does not
know the exact load. One way to overcome this is to measure dur-
ing low load periods (in the very early morning hours, e.g. from 3 to
5 am) and muliply the measurement by 4.
Special case: UMTS/3G and DVB-T: Measure 1 to 2 minutes
their incoming direction tilting the instrument slightly around it.
These special types of signals can sometimes be undervalued by
a factor of 5 by the analysers described here.
Special case: Radar for aviation and navigation. Radar beams are
emitted by slowly rotating antennas. Therefore they are only
measurable and "audio-analysed" every few seconds for millisec-
onds. This necessitates a special approach:
Set "Signal" to "peak". After a couple of radar beam passes read
out the highest number displayed. Because of the slow repetition
rate of the display necessary for all other measurements, the
numbers will vary considerably and will only be displayed for a
very short period of time. When using the HF38B set the switch
to "Peak-hold" and allow for several beam passes to establish
the equilibrium of charging and drooping, which may take a few
minutes.
In most cases the measurement will be at the lower tolerance
band or in the extreme case even up to a factor of 10 too low
For a simplified measurement of UMTS/3G-, DVB-T and Radar
without correction factors, Gigahertz Solutions offers the profes-
sional HF-Analysers HF58B-r and HF59B.
Limiting values, recommendations and
precautions
The "Standard der baubiologischen Messtechnik" (Standard for
Building Biology Measurements), SBM 2008, classifies measure-
ments (per radio communication service), with a note of caution
"pulsed signals to be taken more seriously than continuous ones",
as follows:
Building Biology Recommendations as per SBM-2008
Peak
un-
meas-
conspicuous
urements
< 0.1
µW/m²
In fall 2008 the "Bund für Umwelt und Naturschutz Deutschland
e.V." (BUND) (environmental NGO) recommended a limiting value
of 1 µW/m² even for outdoor situations.
7
Measurement will take longer because of the rapid fluctuations typical especially
for UMTS.
8
Please note that there are also Radar systems operating in the higher Gigahertz
range.
Peak hold
Radar
Peak
Symbolic sketch
moderately
very
conspicuous
conspicuous
0.1 - 10
10 - 1000
© Gigahertz Solutions GmbH
7
in
8
.
extremely
conspicuous
> 1000
© Baubiologie Maes / IBN

Advertisement

loading

This manual is also suitable for:

Hf38bHf35cMe 3030bMe 3830bMe 3840b