Citrus Juicer Attachment; Centrifugal Juicer Attachment; Shredding, Slicing, Grating & Chipping Blade Attachment - Black & Decker FX1000 User Manual

English
Citrus Juicer Attachment ( Fig E)
• Close the safety cover (1) & press it
down until it locks in place.
• Place the processor bowl (11) over the
spindle (6).
• Fit the citrus filter (31) over the spindle
(6) & rotate it anti-clockwise until it locks
in place.
• Fit the reamer (32) over the spindle.
• To remove the attachment, turn the
appliance off & wait until all parts come
to a complete stop then rotate it in a
clockwise direction & lift it from the
appliance.
Note: The citrus juicer will not operate if the
filter (31) is not locked in position.
Centrifugal Juicer Attachment (Fig F)
• Close the safety cover (1) & press it
down
• Place the processor bowl (11) over the
spindle (6).
• Fit the sieve parts (33 & 34) together &
place them inside the processor bowl
(11).
• Fit the centrifugal juicer lid (35) onto the
bowl & rotate anti-clockwise until it
locks in place. Place the pusher (36) into
the hole in the lid.
• To remove the attachment, turn the
appliance off & wait until all parts come
to a complete stop. Rotate the lid (35) in
a clockwise direction & lift it from the
appliance.
• Remove the filter.
Note: The centrifugal juicer will not operate
if the will not operate if the lid (35) is not
locked in position.
Note: Always leave the pusher in place
when an attachment is fitted in the bowl.
Shredding, Slicing, Grating & Chipping
Blade Attachment (Fig D)
• Close the safety cover (1) & press it down
• Place the processor bowl (11) over the
spindle (6).
• Fit the required blade (24, 25, 26, 27, 28
or 29) to the blade carrier. The short,
straight edge of the blade should be
inserted into the rectangular hole in the
carrier first then the curved edge should
be carefully pressed down until it locks in
place.
• Fit the blade carrier (30) over the spindle.
• Place the lid (12) onto the bowl (11) &
rotate clockwise until it locks in place.
• Fit the pusher (17) into the hole in the lid
(12).
• To remove the attachment, turn the
appliance off & wait until all parts come
to a complete stop then remove the
processor lid (12).
• Using the 2 holes provided, lift the carrier
from the appliance.
Note: Always leave the pusher in place
when an attachment is fitted in the bowl.
Note: The appliance will not operate if the
will not operate if the lid (35) is not locked in
position.
Note: Care must be taken when handling
the sharp cutting blades, emptying the bowl
and during cleaning.
-10-