Other Parts 1 X Doorbell - KidKraft F29060 Installation And Operating Instructions Manual

Step 16: Install Ground Stakes
A: In the 6 places shown in fig. 16.1 drive the Rebar Ground Stakes 13" (330mm) into the ground against (041)
Lower Side. Be careful not to hit the washer while hammering stakes into the ground as this could cause the
washer to break off. (fig. 16.1, fig. 16.2 and 16.3)
B: Attach ground stakes using 1 (S7) #12 x 2" Pan Screw (with 2pcs 1/4" flat washers) per ground stake as
shown in fig. 16.2 and 16.3.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
Warning!
driven 13" (330mm) into ground. Digging or driving stakes can be dangerous if
you do not check first for under-ground wiring, cables or gas lines.
Fig. 16.1
Fig. 16.2
S7
Rebar
Ground
Stake
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
To prevent tipping and avoid potential injury, stakes must be
041
041
041
1/4" Flat
Washer
13"(330mm)
In Ground
6 x
S7
Rebar
Ground
Stake
Hardware
#12 x 2" Pan Screw
S7
(with 2pcs 1/4" flat washers)
46
Fig. 16.3
041
1/4" Flat
Washer
13"(330mm)
In Ground
Other Parts
6 x Rebar Ground Stake