Basic Functions; Changing The Pre-Programmed Storage Spaces - Ecom Instruments Ex-PMR 1000 Operating Instructions Manual

8.4.2 Basic functions

1. To switch on, turn the ON/OFF or volume control clockwise until a signal
tone sounds.
2. To control the volume, turn the ON/OFF or volume control while simulta-
neously holding down the monitor key.
3. To select a channel, turn the channel switch to select the respective
channel.
4. To transmit, press and hold PTT and speak into the microphone in a normal
voice. Hold the microphone about 5 cm from your mouth.
5. R elease PTT to receive.
Please observe: If the battery voltage is too low, the transmission process will
stop and the red LED display will flash. Further information can be found at:
8.2 Functions - Low Battery Warning

8.4.3 Changing the pre-programmed storage spaces

8.4.3.1 Channels
You can change the frequency allocation of the 16 pre-programmed channel
storage spaces. Select a value from 0 – 8 to change the frequency allocation
of the selected channel.
Please observe: After programming is complete, switch the unit off and back
on again, so that it is back in the operating mode.
If "0" is selected, the programmed channel is empty (no frequency).
1. Turn the radio unit on while pressing PTT and the monitor key.
Only release PTT and the monitor key when the LED display illuminates
in orange.
2. Press PTT until the LED display changes from orange to green and a signal
tone sounds, which means that the radio unit is in the frequency setting
mode.
3. Select the desired channel using the channel switch.
37