Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
7.
ONCE FLUORESCENT TUBE LAMPS HAVE COOLED AND CAN BE HANDLED WITHOUT RISK OF BURN, CAREFULLY REMOVE FROM EXISTING FIXTURE. AVOID
BREAKING LAMPS.
8.
REMOVE EXISTING FASTENERS AND COVER FROM EXISTING FIXTURE. INVENTORY FASTENERS THAT WERE REMOVED (SCREWS, QUARTER TURN FASTENERS,
ETC.) AND RETAIN FOR LED RETROFIT KIT INSTALLATION.
9.
THE BI-PIN FLUORESCENT SOCKETS WILL NOT BE USED WITH THE NEW LED RETROFIT KIT, REMOVE BY CUTTING WIRES FROM SOCKETS TO INCOMING POWER
FEED AND BALLAST AND REMOVE SOCKETS. CAP WIRES LEFT IN CHANNEL WITH WIRE NUTS OR UL APPROVED ELECTRICAL TAPE (NOT PROVIDED). TO
ABANDON SOCKETS IN PLACE (IF ALLOWED BY LOCAL CODES AND AUTHORITY HAVING JURISDICTION), TURN SOCKETS DOWN INTO METAL CHANNEL AND
NEATLY ARRANGE IN METAL CHANNEL TO AVOID INTERFERENCE WITH NEW LED RETROFIT KIT. USE UL APPROVED ELECTRICAL TAPE TO MOVE ABANDONED
SOCKETS AND WIRE OUT OF THE WAY IF NECESSARY.
10. DISCONNECT EXISTING FLUORESCENT BALLAST FROM INCOMING POWER FEED BY CUTTING BLACK AND WHITE WIRES. BALLAST CONNECTORS CAN BE
RETAINED IF WIRES ARE CUT ON THE LOAD SIDE OF THE BALLAST CONNECTORS (CLOSEST TO THE BALLAST). ABANDON BALLAST IN PLACE (IF ALLOWED BY
LOCAL CODES AND AUTHORITY HAVING JURISDICTION (AHJ)) OR REMOVE. IF BALLAST IS ABANDONED, CAP OF CUT WIRES WITH WIRE NUTS OR UL APPROVED
ELECTRICAL TAPE (NOT INCLUDED). DISPOSE OF UNUSED BALLAST PER LOCAL CODES, IF APPLICABLE.
11. DISCONNECT GROUND FROM FLUORESCENT BALLAST. REMOVE WIRE NUT (IF APPLICABLE) OR CUT GREEN WIRES.
PREPARE EXISTING WIRING (IF APPLICABLE):
1.
USING WIRE CUTTERS, REMOVE INSULATION ON WIRES APPROXIMATELY 3/8" FROM WIRE END. TAKE CARE NOT TO DAMAGE THE COPPER CONDUCTORS.
RETROFIT KIT (RTR)
INSTALLING KIT:
1.
REFER TO "PREPARING EXISTING FIXTURE FOR RETROFIT KIT (RTR) OR RETRO MULTI WIDTH KIT (RMW)".
2.
REFER TO "MAKING ELECTRICAL CONNECTIONS".
FLEXLIGHTINGSOLUTIONS.COM
LIGHTING.TECH@FLEX.COM
LINEAR SERIES
913-851-3000
11-13-17
Advertisement
Table of Contents
