Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
STAND ALONE FIXTURE (FXT) – SURFACE MOUNT
INSTALLING SURFACE MOUNT (FXT):
1.
SEE GENERAL INSTRUCTIONS AT THE FRONT OF THIS SECTION.
2.
8FT AND 12FT SECTIONS: FOLLOW "JOINING FIXTURE SECTIONS" INSTRUCTIONS.
3.
DRIVER IS LOCATED IN SECTION "A."
4.
AC POWER MAY BE FOUND INSTALLED INTO THE BACK, MIDDLE OR SIDE OF THE FIXTURE. ADJUST AC POWER LOCATION, IF APPLICABLE.
5.
CHOOSE A SUITABLE KNOCKOUT LOCATION FROM THOSE PROVIDED. REMOVE THE KNOCKOUT WITH A SCREWDRIVER.
6.
REMOVE LED COVER. (REFER TO SECTION "REMOVING LED COVER – (FXT ONLY)" OF THIS INSTRUCTION.)
7.
LIFT FIXTURE HOUSING TO CEILING AND MARK THE MOUNTING HOLES WITH A PENCIL.
8.
PULL EXISTING AC POWER FROM BUILDING THROUGH KNOCKOUT LOCATION INTO FIXTURE HOUSING. PROVIDE UL APPROVED STRAIN RELIEF (NOT PROVIDED)
AS REQUIRED.
9.
RAISE FIXTURE HOUSING TO SURFACE AND SECURE WITH APPROPRIATE CONNECTOR(S).
10. MAKE FINAL WIRING CONNECTIONS. REFER TO "MAKING ELECTRICAL CONNECTIONS".
PREPARING EXISTING FIXTURE FOR RETROFIT KIT (RTR) OR RETRO MULTI WIDTH KIT (RMW)
PREPARING EXISTING FIXTURE:
1.
SEE GENERAL INSTRUCTIONS AT THE FRONT OF THIS SECTION.
2.
RETROFIT LUMINAIRE CONVERSION KIT IS SUITABLE FOR USE IN A FULLY ENCLOSED LUMINAIRE.
3.
RETROFIT LUMINAIRE CONVERSION KIT IS NOT INTENDED FOR DIRECT CONTACT WITH WATER.
4.
IDENTITY FLUORESCENT FIXTURE BEING UPGRADED WITH LED RETROFIT KIT.
5.
TURN FLUORESCENT FIXTURE OFF AND ALLOW LAMPS TO COOL PRIOR TO STARTING WORK.
6.
IF FLUORESCENT FIXTURE HAS LENS OR DIFFUSER, REMOVE TO GAIN ACCESS TO LAMPS.
TRADITIONAL
FLUORESCENT
FIXTURE
FLEXLIGHTINGSOLUTIONS.COM
LIGHTING.TECH@FLEX.COM
LINEAR SERIES
SECTION "A"
913-851-3000
11-13-17
Advertisement
Table of Contents
