Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
APPLIES TO STAND ALONE FIXTURE (FXT); RETROFIT KIT (RTR); RETRO MULTI WIDTH KIT (RMW)
4.
4FT FIXTURE, SECTION "8A" AND "12A" (FXT OR RTR): HOLD LED LIGHT COVER UP TO FIXTURE HOUSING (OR EXISTING HOUSING, IF APPLICABLE).
5.
(RTR OR RMW) - POSITION LED DRIVER (LOCATED ON BACK SIDE OF LED RETROFIT KIT) IN AN ORIENTATION THAT DOES NOT CONFLICT WITH THE ABANDONED
FLUORESCENT BALLAST (IF APPLICABLE). THE LED HOUSING CAN BE ROTATED 180 DEGREES (RTR, IF APPLICABLE.)
6.
MAKE ELECTRICAL CONNECTIONS PER ALL APPLICABLE CODES:
NORMAL POWER WIRING - BLACK TO BLACK (HOT); WHITE TO WHITE (NEUTRAL) AND GREEN (OR BARE) TO GREEN (GROUND). ENSURE NO BARE
WIRES ARE EXPOSED.
DIMMING WIRING – VIOLET TO VIOLET (DIM +); GREY TO GREY (DIM -)
EMERGENCY WIRING (WITH SWITCH LEG) - BLACK TO BLACK (HOT); BLACK TO BLACK/RED STRIPE (SWITCH); WHITE TO WHITE (NEUTRAL) AND GREEN
(OR BARE) TO GREEN (GROUND). ENSURE NO BARE WIRES ARE EXPOSED.
EMERGENCY WIRING (WITHOUT SWITCH LEG) - BLACK TO BLACK (HOT) AND BLACK TO BLACK/RED STRIPE (SWITCH) (SAME CONNECTOR); WHITE TO
WHITE (NEUTRAL) AND GREEN (OR BARE) TO GREEN (GROUND). ENSURE NO BARE WIRES ARE EXPOSED.
7.
(FXT, RTR, RMW) NEATLY ARRANGE THE WIRES AND ENSURE ALL THE WIRES AND CONNECTIONS ARE SEALED PROPERLY INSIDE THE FIXTURE HOUSING. TAKE
CARE NOT TO PINCH ANY WIRES.
8.
(FXT) 4FT SECTION: ATTACH LED LIGHT COVER TO FIXTURE HOUSING. ENSURE ALL WIRING IS SAFELY TUCKED INSIDE THE INTERIOR OF THE FIXTURE BEFORE
FINALIZING INSTALLATION. ATTACH LED LIGHT COVER WITH SELF-TAPPING SCREWS (PROVIDED).
FLEXLIGHTINGSOLUTIONS.COM
LIGHTING.TECH@FLEX.COM
LINEAR SERIES
913-851-3000
11-13-17
Advertisement
Table of Contents
