Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT: READ ALL INSTRUCTIONS THOROUGHLY AND CAREFULLY PRIOR TO INSTALLATION OF LINEAR
SERIES FIXTURES AND RETAIN FOR FUTURE REFERENCE.
INSTALLING SUSPENSION MOUNT (FXT):
1.
SEE GENERAL INSTRUCTIONS AT THE FRONT OF THIS INSTRUCTION.
2.
4' SECTION: PRESS GRIPPER AGAINST CABLE SO GRIPPER AND CABLE ARE PARALLEL.
3.
INSERT GRIPPER/CABLE INTO FIXTURE THROUGH OBLONG HOLES AT END OF FIXTURE.
4.
PUSH GRIPPER/CABLE THROUGH HOLE UNTIL GRIPPER CANNOT BE HANDLED (IS NOT SEEN).
5.
PULL CABLE TIGHT. GRIPPER LAYS INSIDE FIXTURE HOUSING AND WILL NOT PULL OUT.
6.
SECURE HANGER CABLE TO STRUCTURE.
a.
4FT SECTION: MINIMUM 2 HANGER POINTS
b.
8FT SECTION: MINIMUM 3 HANGER POINTS OR 4 HANGER POINTS.
c.
12FT SECTION: MINIMUM 4 HANGER POINTS OR 6 HANGER POINTS.
7.
PASS LOOP SIDE OF CABLE OVER, AROUND AND UNDER STRUCTURE.
8.
PASS STRAIGHT END OF CABLE THROUGH LOOP AND PULL TIGHT.
9.
RAISE FIXTURE WITH "Y" TOGGLE AND GRIPPER TO LOOP CABLE SECURED TO STRUCTURE.
10. PASS STRAIGHT END OF LOOP CABLE THROUGH TOGGLE. PLUNGER ON TOP OF TOGGLE CATCHES AND HOLDS CABLE SECURELY.
11. LEVEL FIXTURE PLUMB WITH BUILDLING LINES. (TO LET OUT CABLE, PUSH PLUNGER DOWN).
12. MAKE FINAL WIRING CONNECTIONS. REFER TO "MAKING ELECTRICAL CONNECTIONS".
13.
8' SECTION: FOLLOW INSTRUCTIONS FOR "4FT SECTION", NUMBERS 2 THROUGH 5 TO INSTALLED TOGGLE AND GRIPPER.
14. INSTALLING MIDDLE TOGGLE/GRIPPER FOR 3 HANGER POINTS: PRESS GRIPPER AGAINST CABLE SO GRIPPER AND CABLE ARE PARALLEL.
FLEXLIGHTINGSOLUTIONS.COM
LIGHTING.TECH@FLEX.COM
LINEAR SERIES
FIXTURE
SECTION THROUGH FIXTURE
STRUCTURE
913-851-3000
11-13-17
Advertisement
Table of Contents
