Miele SmartLine CS 7611 Operating And Installation Instructions page 57

Installing the SmartLine element
 Stick the supplied sealing strip under
the edge of the SmartLine element.
Do not apply the sealing strip under
tension.
 Feed the mains connection cable
down through the worktop cutout.
 Position the SmartLine element in the
worktop cutout. When doing this,
make sure that the seal of the appli-
ance sits flush with the worktop on all
sides. This is important to ensure an
effective seal all round.
 Connect the SmartLine element to
the mains electricity supply.
 If required, connect the SmartLine
element to the gas supply (see "In-
stallation – Gas connection").
 Check that the SmartLine element
works.
 Seal the gaps between the individual
elements and between the elements
and the worktop with a silicone seal-
ant that is heat-resistant to at least
160 °C.
Unsuitable sealant can damage nat-
ural stone.
For natural stone worktops and nat-
ural stone tiles, only use silicone
sealant that is specially formulated
for natural stone. Follow the manu-
facturer's instructions.
Checking operation
 After installation, ignite all burners to
check that they are operating cor-
rectly:
– The flame must not go out on the
lowest setting, or when the control is
turned quickly from the highest to the
lowest setting.
– On the highest setting, the flame
must have a distinctive and visible
core.
Installation
57