I-View AnyCam DM-12MIPS Operation Manual page 29

Table of Contents

Advertisement

and double click that the detail information will show the right site; you can do the change the
setting for this IP camera individually.
 Install video codec: Install the video codec of this IP camera when you connect IP camera at
first time, if the IP camera cannot show the video on the screen.
The detail setting of Fig A diagram description as below:
 Discover: Click "Discover" icon to research the IP address of system.
 Auto configure section- Click this icon to configure the selected IP cameras to NVR's
channel automatically. Please refer the diagram shown as above Fig B.
• Clear all setting: Check this icon and all previous channels setting will be clean.
• Capture audio: You can record sound by microphone from audio input port of IP camera.
• Synchronization with the NVR time: Check to synchronize the time of IP camera with
NVR when run the NVR program.
• Video system: Select the video system of IP camera to match your country.
Auto assign IP address section- Click this icon to assign the IP address to all IP cameras
automatically. You can use the Static or DHCP IP address mode. There are two setting
modes for the Static IP address; one is "Original" the other is "User define". Please refer
the diagram shown as above Fig C.
Original- The IP address which want to change to static IP address will same as the
searched IP address.
User define- The user can assign the segment of IP address for IP camera. Please make
sure the process as below before do this process:
a. There is no conflict between the define IP address and the other device of the same LAN.
b. The Username/Password of all IP cameras are the same.
This function for I-View's IP camera only.
 Change IP: Click "Change IP" icon to setup the DHCP or Static IP address for individual
IP cameras. After modification, click "OK" icon to confirm the setting.
 Update firmware: Click "Update firmware" icon to update the newest IP camera firmware;
you can check and download the newest firmware version from our website:
www.i-view.com.tw .
 Reboot: Click "Reboot" icon to restart this IP camera.
29

Advertisement

Table of Contents
loading

Table of Contents