I-View AnyCam DM-12MIPS Operation Manual page 23

the screw anchors into the holes. If you want to feed wiring from the hole on the top of the
back case, create a circular opening (bottom conduit hole) in the mounting surface.
3) Press the Ethernet cable into the routing path at the bottom of the camera so that the cable will
not get in the way when the metal mounting plate is attached, and then arrange these cables
through the hole of ceiling or wall.
4) Align the back case and the lens base, and then fasten the TP4 screws into the inserted anchors.
5) Adjust the focusing position by rotating and panning the camera base. Note that the back case
side conduit hole is the point where the camera will not rotate past.
6) Fix the cover to finish the camera installation.
23