Table of Contents
Advertisement
4. Remove the eight screws on both sides of the unit.
Attach the inner rails to the unit using the eight screws
supplied.
Inner rail
B4 x 8
5. Remove the four screws on both sides of the unit.
Attach the rack angles to the unit using the four screws
supplied.
Rack angle
PSW
4 x 16
MAV-555A
Attaching the outer rails to the rack
1. Attach the brackets to the outer rails 1 with plate nuts
Inner rail
B4 x 8
2. Adjust the outer rail position so that the distance
Rack angle
PSW4 x 16
(long) and the screws temporarily as shown.
n
Attach the brackets such that the screw hole of the
outer rail 1 becomes visible when the outer rail 2 is
moved to the front and rear.
Plate nut
Bracket
Plate nut
B4 x 8
Outer rail 2
between the rack angle mounting surface and the outer
rail 1 tip becomes 50 to 55 mm as shown when the
outer rail is attached to the rack. Tighten the screws
of the bracket that were temporary tightened in step 1.
Rack angle
Rack
mounting surface
50 to 55 mm
1-6. Rack Mounting
Bracket
Outer rail 1
B4 x 8
Outer rail 1
1-9 (E)
Advertisement
Table of Contents
