Sony MAV-555A Installation Manual page 12

1-5. Installing the Option Boards
10. While removing play of the cables by pulling them in
the direction of arrow A, fix the cables with the
harness clamper 1.
11. While removing play of the cables by pulling them in
the direction of arrow B, pull up the top of the re-
usable band in the direction of the arrow, and tie the
cables.
12. While removing play of the four cables that are
connected to the BKMA-540 by pulling them in the
dirrection of arrow C, fix the cables with the harness
clamper 2.
13. Cut the excess length of the re-usable band so that
extra length of 2 to 3 mm is left.
View from the top
(six cables)
View from the top
Top of the band
(four cables)
Harness
clamper 2
2 to
3 mm
C
n
For all the procedures after installation of the BKMA-540
is completed, refer to the BKMA-540 Installation Manual.
1-6 (E)
Cables
Harness
clamper 1
A
Cut here
A
B
Re-usable band
Installing the BKMA-560
n
For all the procedures before starting installing the
BKMA-560, refer to the BKMA-560 Installation Manual.
1. Open the two harness clampers and remove the cable
([BLU]) and the cable ([GRN]) one cable after
another. (See Fig. 1.)
2. Fix the cables using the harness clamper at the two
locations. (See Fig. 2.)
Cable
([BLU])
Cable
([GRN])
View from the top
Fig. 1
Harness clampers
Fig. 2
Harness clampers
MAV-555A