Assembly; Safety During Assembly; Other Assembly Requirements - LOGICDATA LOGIC OFFICE Series Manual

6 ASSEMBLY

This chapter describes the process of installing the LOGIClink into the Height-Adjustable Table System.
6.1

SAFETY DURING ASSEMBLY

The assembly location must be level, vibration-free and free from dirt, dust, etc. Ensure that there is no ex-
cessive exposure to dust, toxic or corrosive gases and vapors, or excessive heat at the location. The following
safety instructions are valid for all LOGIClink products.
CAUTION Risk of minor or moderate injury through improper handling
Improper handling of the product during assembly may lead to minor or moderate in-
jury through cutting, pinching, and crushing.
• Avoid contact with sharp edges
• Be careful while handling tools that may cause personal injury
• Ensure assembly complies with the generally accepted standards and guidelines of
electrical engineering and furniture manufacturing
• Read all instructions and safety advice carefully
CAUTION Risk of minor or moderate injury through tripping
During assembly and operation, poorly routed Cables may become a trip hazard.
Tripping over Cables may lead to minor or moderate injury.
• Ensure that Cables are routed properly to avoid trip hazards
• Be careful not to trip over Cables when installing the LOGIClink
NOTICE
Ensure proper ESD handling during assembly. Damage that can be attributed to electro-
static discharge will void warranty claims.
To avoid damage to the LOGIClink, measure its dimensions before assembly.
NOTICE
NOTICE
Before assembly, all parts must be acclimatised to the ambient conditions.
INFO
Perform a product risk assessment so that you can respond to potential residual haz-
ards. Assembly instructions must be included in your end user Operating Manual.

6.2 OTHER ASSEMBLY REQUIREMENTS

LOGIClink is suitable for table tops made of medium density fiberboard (MDF), high density fiberboard
(HDF), and plywood. The thickness of the table top be a maximum of 31 mm. Thicker surfaces will prevent
the NFC reader from functioning properly. Screws, cables, and other metal parts must be at least 5 cm away
from the LOGIClink.
LOGICLINK - MANUAL // PAGE 14