Assembly - Fakir prestige VC 20 S Operating Instructions Manual

en
WARNING!
Never use a defective appliance.
WARNING!
Prior to assembly, make sure that the mains
plug is unplugged. If the mains plug is plug-
ged in, the appliance could accidentally be
switched on, resulting in injuries.
NOTICE!
Left-handed thread! Screw on the nut counter-clock -
wise. Note the flat surface on the motor axle
Assemble in the following order:
If not already pre-mounted, remove the cap nut [15] from the tube [16] and push the
cover [17] over the telescopic tube. Pull out the telescopic tube [14] and then put on
the cap nut [15] again. Insert the 4 base feet [18] through the 4 holes in the cover [17]
onto the foot connector [19] and secure with the enclosed screws.
Place the back protective grille [7] exactly onto the motor head [10] (insert the two pins
on the motor head into the two holes in the protective grille) and screw tight using the
included cap nuts [6].
Place the fan blades [5] all the way onto the motor axle and secure with the included
cap nut [4] (left-handed thread
ATTENTION!
Never twist the motor head by force.
Never push on the protective grid.
10

Assembly

!
). If necessary remove the protective tube.