Pga Processor And Heatsink Installation - Supero SUPERSERVER 6012P-6 User Manual

S
UPERSERVER 6012P-6 User's Manual
5-2

PGA Processor and Heatsink Installation

When handling the processor package, avoid placing direct
pressure on the label area of the fan. Also, do not place the
! motherboard on a conductive surface, which can damage the
BIOS battery and prevent the system from booting up.
IMPORTANT: Always connect the power cord last and always remove it before
adding, removing or changing any hardware components. Make sure that you
install the processor into the CPU socket before you install the heatsink. The
P4DPR-6GM+ can support either one or two Xeon 512K L2 cache processors of
up to 3 GHz. If installing one processor only, install it into CPU socket #1.
1. Lift the lever on the CPU socket.
Lift the lever completely or you will
damage the CPU socket when
power is applied. (Install a
processor into CPU #1 socket
first.)
2. Install the CPU in the socket.
Make sure that pin 1 of the CPU is
seated on pin 1 of the socket (both
corners are marked with a
triangle). When using only one
CPU, install it into CPU socket #1
(CPU socket #2 is automatically
disabled if only one CPU is used).
3. Press the lever down until you
hear it *click* into the locked
position. See Figure 5-1 for
pictures of the 603-pin CPU socket
before and after the processor is
installed.
Socket lever
Pin 1
Socket lever in
locked position
5-2