Table of Contents
Advertisement
S
UPERSERVER 6012P-6 User's Manual
4. When installing modules into the two Bank 2 slots, you will need to
remove the power supply due to space constraints. Memory slots are
positioned at a 25 degree angle to fit full-sized memory modules into a
1U chassis.
Memory Support
The P4DPR-6GM+ only supports ECC registered DDR-200 (PC1600) SDRAM
memory. DDR-266 (PC2100) SDRAM is supported but only at 200 MHz (DDR-
200 speed). PC100/133 SDRAM is not supported. You should not mix DIMMs
of different sizes and speeds.
See Figures 5-5a and 5-5b for installing and removing memory modules.
Figure 5-5a.
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward
to free the DIMM from the slot.
Side View of DIMM Installation into Slot
Figure 5-5b.
Top View of DIMM Slot
5-8
Advertisement
Table of Contents
